OFFERED BY
Boatpoint
LOCATION
Conwy United Kingdom
YEAR
1973
LENGTH
25.72 ft.
Condition
Used
Year
1973
Make & Model
TRESFJORD Cutlass 26
Boat type
Power
Length
25.72 ft.
Location
Conwy United Kingdom
Beam
8.73 ft.
Draft Max
2.76 ft.
TheTresfjord Cutlass 26 is a typical Scandinavian Motor Cruiser, well built and well designed. The cockpit is made good use of and enlarged by having the galley in it. This also allows the cabin to have a good sized double berth rather than cluttering it with the galley. Designed by Jens K Skorgenes, built in Norway and regarded as a solid, seaworthy boat. Based on Conwy Marina, North Wales. Viewing by appointment.
Designed and built in Norway designed by Jens K Skorgenes
Epoxy treated GRP hull and superstrcuture
Spade rudder
LOA:7.84M
BEAM:2.66M
DRAFT: 0.84M
Engine:
Lombardi LOW 2204M 60hp 4 cylinder diesel shaft driven engine (replaced in 2010), last serviced2024. Hours are currently 222.
Shaft seal changed 2023
Three bladed propeller & rope cutter
Electrical:
2x 12v 100ah batteries charged by engine alternator or 240 volt battery charger. batteries last replaced 2021
Water:
Pressurised Water System & Hot Water Calorifier.
Tankage:
Stainless steel fuel tank 100l & 80l
Water tank 80l
Gas:
Gas hoses replaced 2022
Navigation lights
Garmin Ecomap Plus 60 plotter
Vesper XB AIS transponder
Nasa Clipper Duet speed, depth, log
Silva s10 DSC VHF
Autohelm 300 autopilot
Ritchie Compass
Cockpit speakers
Electric and manual bilge pump
Anchor and 40m chain
Cockpit cushions
Warps and fenders
Stainless steel davits
Shore power cable
Boathook
Yacht legs
Clock & barometer
3x fire extinguishers
Gas alarm
4 man canister life raft
Seago Tender and 3.5hp Mercury outboard
Immersion heater - 240v
Gas hob
Domestic electric 12v/240v fridge
Fire blanket
4 berths over 2 cabins
Access into the cockpit is provided with a step down from the side decks. The cockpit are is laid out with the helm on the port side with a single helm seat. On the starboard side there is a single co pilot seat which folds down to provide an extended work surface area with a galley equipped with a twin gas Flavel Vanessa burner and sink.
The forward cabin has bench seats in the bow of the boat with a table that converts to provide a double berth. There is a storage locker and a separate heads.
The aft cabin provides a further double berth.
HULL
Hull Material
fiberglass
The TRESFJORD Cutlass 26 is 26 feet long that boasts a 8.7 feet beam and a draft of 0.84 meters. The TRESFJORD Cutlass 26 is made of fiberglass.