Search Similar
  1. Home

Boats similar to Chuck Paine 42 Cutter

Boat not available.

Chuck Paine 42 Cutter for sale in Marina Del Rey CA United States of America

LOCATION

Marina Del Rey CA United States of America

YEAR

1982

LENGTH

41.99 ft.

DETAILS

Condition

Used

Year

1982

Make & Model

Chuck Paine 42 Cutter

Boat type

Sail

Length

41.99 ft.

Fuel Type

Diesel

Location

Marina Del Rey CA United States of America

MEASUREMENTS

Beam

12.66 ft.

Fresh Water Tanks

130 gal

DESCRIPTION

Remarkable & Rare Chuck Paine Cuttter World Cruiser built in Maine under the designer's supervision.

This vessel became the originator of the famous Cabo Rico Yachts.

Effortless, gentle sailor, completely remodeled, upgraded, and refitted the last 2 years. She is in pristine condition.

Upgrades & Retrofit 2020 / 2022. More than $ 200,000.00 was spent.

Hull Work.

- New Bottom Paint.

Remarkable & Rare Chuck Paine Cuttter World Cruiser built in Maine under the designer's supervision.

This vessel became the originator of the famous Cabo Rico Yachts.

Effortless, gentle sailor, completely remodeled, upgraded, and refitted the last 2 years. She is in pristine condition.

Upgrades & Retrofit 2020 / 2022. More than $ 200,000.00 was spent.

Hull Work.

- New Bottom Paint.

- New Holding Tank.

- New Hull Fittings & Valves with New Marelon Fittings.

- Remove & Inspect Shaft, replace Strut Bearing, remove the Rudder, and repair Rudder Post.

- Remove Fiberglass & Wood for Chain Plates. Fill the Gap with Fiberglass, build Primer & Sand. Lay Out New Wood Rail on the Port & Starboard Hull Sides, and apply 2 cloth laminations with West Epoxy over Wood Rail on the Port & Starboard Hull Sides.

New Rigging.

- New Standing Rigging including Inner Forestay, Forestay.

- New Carbon Whisker Pole.

- Mast New Painting.

- New Mast & Navigation Lights (LED).

- New Running Rigging (Main Sail, Staysail, Genoa Halyards. Boom Topping Lift. Furling Lines).

- New Main Sail Furling System.

- All Winches Serviced.

- New Chain Plates.

- New Self-Tailing Mast Winch Size 45.

- Cruising Arch integrated into solid side railing & split stern railing/lifting arms with sheet blocks.

- Stainless Tiller Cap for Steering Vane Post Removable Tiller.

- Folding Port Side Solid Teak Seat with integrated Stainless Hardware.

Mechanical.

- New Transmission.

- Inspect & Upgrade Exhaust System.

New Sails.

- New Mainsail 9.2 Oz. Dacron Leisurefurl Finish from UK Sails.

- New Furling Staysail.

- New Furling Yankee.

- New Asymmetrical Cruising Spinnaker.

New Electrical.

- New 12 Volt 400 Amp Hour Lifep04 Lithium Battery with Bluetooth Monitoring.

- New Stainless Wrapped Solar Panel Mounting Frame integrated into the arch.

- New IHI RHB5 Turbocharger.

- New Anchor Battery Wiring.

- New Batteries Monitor.

New Electronics.

- New Boat Speed/Temperature Transducer.

- New Raymarine Smart Controller Wireless Pilot.

- Simrad HS 40 Wireless Remote for RS40 VHF/AIS

- New Raymarine EV400 Sail Pilot for Type 2-3 Drive.

- New Raymarine i70 DISPLAY.

- New Raymarine i60 Wind Pack

Including:

Custom extended bow pulpit.

Solar Panels.

Davits for Tender Lift.

Full Battened Mainsail in Furling Boom.

Disclaimer

The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. Hours listed may vary from actual hours due to recent use. Purchaser is encouraged to verify hours prior to purchase. This vessel is offered subject to prior sale, price change, or withdrawal without notice.

ADDITIONAL INFORMATION

HULL

Hull Material

fiberglass

OTHER

Fuel Tanks Capacity

60 gal

ABOUT CHUCK PAINE 42 CUTTER

The Chuck Paine 42 Cutter is 42 feet long that boasts a 13 feet beam. The Chuck Paine 42 Cutter is made of fiberglass.

SIMILAR LOCATIONS