Gillissen Kotter 1200 AK for sale in Lelystad, Netherlands

Classic motorsailer, suited to run dry and for making beautifull trips.

This Gillissen cutter has the characteristic lines of a ship designed by Theo Gillissen. The current (2nd) owner is in possession of the building plans. After blasting in 2008, the steel, round truss, jogged hull is epoxy coated and finished with a single-component paint and antifouling.

The ship has a continuous keel (at a depth of 120 cm) with a center sword that can be retrieved with a hand winch (up to 180 cm). Two solid keel keels (also 120 cm) were added later to allow comfortable upright descent. The two masts are made of wood, the sail wardrobe consists of 4 sails, including gaff. The sails can be operated with 2 winches. This boat is brokered through the White Whale Yachtbrokers Enkhuizen office. If you are interested please contact us at enkhuizen@wwy.nl or +for more information or to make an appointment for viewing on board. Viewings are possible from Monday to Saturday.

General
Windows: Hora Leusden, Bronze portholes and other windows: aluframes, all hardened glass
Vertical clearance: not accurately measured
Other:

Dimensions such as the draught, headroom and water displacement are estimated, but close to the precise size; 2nd owner; insulation with polystyrene; skin thickness 4 and 5 mm (according to drawing); construction drawings and photos of construction available for inspection; emergency tiller on rudder axel is possible.

Accommodation
Material, colours: blue upholstery in salon, in front and aft cabin checkered upholstery
Curtains: blue
Saloons: wheelhouse, salon with pantry
Berths: front- and aft cabin, length birth ca 220 cm
Headroom: approximately
Cooker & fuel: Propane (2 bottles)
Engine, electrics, water
Engine hours: approximately
Cooling system: cooling pipes in outside water
Dynamo: 1 x 12 V and 1 x 24 V
Solar panel: 250 Wp
Hot water: via geyser with automatic electric ignition
Water tank & material: 2 x 200 ltr tank
Voltmeter: 12 and 24 Volt
Other:

12 V alternator mounting bracket has some play

Rig and sails
Spars, stays: Spar: wood; Stays stainless steel
Sail lowering system: for big mast
Mizzen: ca 10 m2 gaff rig with slabreef
Jib: ca 8 m2 selftacking jib
Flying jib: approx 8 m2
Other:

Sails are old, but barely used

Navigation and electronics
Charts, guides: Baltic Sea and various pilots
Other:

PC with touchscreen for navigation and AIS; GSM switching module and Carvox Explorer; radio receiver Sailor R108

Equipment
Anchor windlass: Lofrans Tigres 1500 W
Swimming ladder: brackets
Sea rails, pushpit, pullpit: stainless steel
Dinghy: optional
Outboard engine: optional