Boat not available.
LOCATION
Port Charlotte, Florida United States of America
YEAR
1977
LENGTH
29.53 ft.
Condition
Used
Year
1977
Make & Model
Endeavour 32 Masthead Sloop
Length
29.53 ft.
Fuel Type
Diesel
Location
Port Charlotte, Florida United States of America
Beam
9.74 ft.
Draft
4.17 ft.
Estate Sale. Boat was Just Powered into Storage Yard and runs great. She Features a 2015 Yanmar with only 75 Hours. She is also a very solid boat Everything that goes with the boat is inside the cabin, so she is a bit cluttered. If you can see past the clutter you will have a gem. Contact us Today!!
*2015 Yanmar Diesel Engine, *21 HP, *75 Hours, *Fresh Water Cooled, *2015 Transmission, New Thru Hulls 2015 (All) *Dual Batteries, *Dual Battery Switch, *Inverter, * GPS, Chart Plotter, *Auto Pilot, *Power Winch Handle, *Inflatable Dingy, *MORE!!
COCKPIT ACCOMMODATIONSCaptain's Chair w Arm Rests
Cockpit Cushions
Seats 7
Bimini Top
Cockpit Canvas Enclosure (In Bag not Itemized)
Main Sail Cover
Stainless Steel Steering Wheel
Helm Electronics Station
Newer Interior Upholstery
V-Berth Forward w Hanging Closet
Settee to Both Port and Starboard
Convertible Dinette
Aft Quarter Berth
Enclosed Head Compartment w Stand Up Fresh Water Shower and Jabasco Flushing Toilet
Galley
Origo 4000 Alcohol 2 Burner Stove
Stainless Steel Sink
Ice Box
Engine, Transmission, Shaft and Thru Hulls all Brand New in 2015
Yanmar 3YM20 Engine w 75 Hours
Fresh Water Cooled
Winch Rite Power Winch Cordless
Bilge Pump
GPS and Chart Plotter (Not onboard, will be identified at a later date)
Raymarine Auto Pilot
Standard Horizon VHF Radio
Data Marine Speed Gauge
Data Marine Depth Finder
SR Mariner Wind Speed
Brand New Ritchie Compass
30 Amp Shore Power
Shore Power Cord
1000 Pro Watt Inverter
Dual Batteries
Dual Battery Switch
Mainsail in Good Condition
Genoa in Good Condition
Standing Rigging is Good
Running Rigging Fair to Good
Lewmar 30 Winches Port and Starboard Appear Excellent
Spinnaker Pole
Pro Furl Genoa Furling
8' Quicksilver Inflatable Dinghy w Carry Bag
The Endeavour 32 began life back in 1970 as the Irwin 32. Ted Irwin designed her as a dual purpose cruiser-racer before the development of the IOR. By 1975, the IOR was in full swing, and boats such as the Irwin 32 were obsolete as racers, since PHRF had not yet emerged to help handicap non-competitive boats raced at the club level.
Although the Irwin 32 had been out-designed for racing, the hull was still a comfortable design for cruising. The molds for the Irwin 32 formed the basis for Endeavour Yacht Corporation, which continued to build the boat as the Endeavour 32 until 1982.
Although the Irwin 32 and the Endeavour 32 look identical and have the same displacement, the Endeavour 32 is listed by the builder as being 4" wider, 4" longer overall, and 6" longer on the waterline.
Although the rig of the Endeavor 32 is fairly large, her relatively heavy displacement compared to dual purpose 32-footers built today makes her somewhat slower than a more modern boat of the same overall length. The Endeavour 32’s ballast/displacement ratio of 40% implies a fairly stiff boat, but because of the boat’s shoal draft and narrow beam she is not as stiff as newer, lighter boats of the same length. While the Endeavour 32 is not a tender boat, her narrow beam and relatively high center of gravity mean she will heel fairly quickly.
All Endeavour 32s came with diesel engines, but there is a lot of difference in the engines that were used. In 1975, 1976, and 1977 models, a 12 hp Yanmar diesel was standard equipment. In our opinion, that engine is simply too small for a boat this size. It will be fine in a flat calm, but there’s not enough power to push the boat into any wind or sea. Some boats in the same period were equipped with the Westerbeke L-25 engine, and others with the Yanmar 2QM20. The bigger Yanmar became standard in 1978, but a three-cylinder Universal diesel of about 24 hp was also an option in late-model boats.
No owners responding to our survey report major structural problems. There are, however, reports of hairline gelcoat crazing on both the hull and deck. One owner also reported extensive deck delamination. Still another comments that a surveyor found loose tabbing around a bulkhead in the forward cabin. In general, there were a higher than average number of owner complaints about gelcoat.
The frequency of bottom blistering reports is about average for boats generally sailed in warmer waters.
For a relatively narrow boat, the Endeavour 32 is roomy. Headroom on centerline is about 6' 4". The original stepped cabin trunk—an Irwin design trademark—was replaced in the middle of the boat’s production history with a more modern-looking cabin trunk which is slightly tapered in profile. Cabin headroom was not significantly altered. Headroom is carried well forward over the forward cabin.
The Endeavour 32 is a comfortable, reasonably capable cruising boat. It would make a good coastal cruiser or island hopper. The basic design and construction are sound enough to justify the numerous additions and modifications necessary to make the boat suitable as a limited offshore cruiser for areas such as the Bahamas or the Caribbean.
Engine Count
1
Engine Horse Power
21.00
Engine Hours
75.00
HULL
Hull Material
Fiberglass
OTHER
Single Berths
5
Engine Year
2015
Engine Type
Inboard
Fuel Capacity Gal
20
No of Heads
1
Water Capacity Gal
65
The Endeavour 32 Masthead Sloop is a 30 feet long that boasts a 9.7 feet beam. and can hold up to 20 gallons of fuel.and 65 gallons of water.This 1977 diesel Endeavour 32 Masthead Sloop is powered by a Yanmar 3YM20, with 21.00 horsepower. The Endeavour 32 Masthead Sloop is made of fiberglass.